Advanced Outdoor Latex Paint For Exterior Wall Painting Paint

PRODUCT DESCRIPTION

This product, which has strong resistance to water alkali and stain, is mainly prepared by advanced pure acrylic copolymer resin, the finest natural stones and auxiliaries.

After the coating is applied, it is non-toxic and long lasting with high adhesion, so that customers have a strong sense of reality, elegance and harmony.

Typical Uses:

This product is designed for protection and decoration of building exterior wall, for instance, hotel, hospital school and factory, because it will not cause yellowing and deterioration of the paint film over time when exposure to direct sunlight. Substrates such as cement mortar, concrete and masonry are applicable as well.

Application Guide

● Mixing:

Ready to use.

● Thinner:

Clean water.

● Airless Spray:

According to the decoration requirements, it can be divided into monochromatic primary coating and composite primary coating. If choose monochromatic primary coating: it can use both full spray and spot spray, and exclusive dual or triple spray gun. The same is true for composite primary coatings. Nozzle tip and spray pressure are selected according to the color matching.

● Spray, brush, roller:

Recommended must achieve required thickness.

DRYING SCHEDULE

SURFACE TREATMENT

Surface treatment of each base layer: The quality of the coated cement slurry and concrete base layer shall comply with JGJ73-91 construction and acceptance specifications for building decoration engineering.

The surface of the substrate must be clean, dry, solid, free from oil and other dirt. The PI value is less than 10. If there is an old coated wall, the loose, peeled, powdered coating should be removed and smoothed with sandpaper.

In the case of moldy walls, wash the wall with 25% bleach hot water, leave the washing liquid on the surface for 10 minutes, then rinse thoroughly with water, dry for 48 hours before painting. Surface pock and crevices should be coated with the company's construction materials putty. It is necessary to construct the treated wall as soon as possible after drying to avoid reontamination.

APPLICATION

Application conditions: Substrate temperature shall be at 3 °C higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.

CLASSICAL COATING SYSTEM

Please inquiry JIANBANG paint for specific coating solutions.

Advanced Architectural Latex Paint Sealing Primer: 1*20µm (dry film thickness)

Advanced Exterior Putty: 1～2mm (dry film thickness)

Natural Stone Textured Paint: According to the thickness of stone(dry film thickness)

SAFETY AND HEALTH

Please refer to MSDS before using this product. If you do not fully understand the restrictions, or cannot follow MSDS directions strictly, do not use this product. This volatile product is flammable. Keep this product away from flame or fire. Smoking is strictly prohibited in working area. Keep working area ventilated during application to make sure solvent vapor content is low in the air. PPE is necessary to avoid this product contacting with eyes or skin. More detailed safety tips are based on practical situation.

Please handle used paint barrel correctly to avoid any pollution.

Storage:

Store this product in shady, dry, and ventilated warehouse. Storage temperature should be above 0℃. The shelf life is 12 months at room temperature. If exceeding shelf life, the products shall be tested before using.

Disclaimer:

All technical data given in this document is based on our knowledge achieved in lab and practice, it is not completely correct. Although we try to keep the validity of our advice, however we cannot predict the practical conditions that will affect paint quality. Herein, we cannot be responsible for the consequences of variations in such conditions, or for unforeseen conditions. We reserve the right to modify this document without informing in advance.

Certificate