Oem Epoxy Zinc Phosphate Anti-rust Paint with Excellent Anti-corrosive Performance Factory Price-JIANBANG

PRODUCT DESCRIPTION

This product is a two-component epoxy paint composed of epoxy resin and polyamide curing agent. Meanwhile, the paint contains zinc phosphate corrosion inhibitor pigment and has excellent anti-corrosive performance and hard film. Besides, it also has impact resistance and wear resistance

Typical Uses:

This product can be used as primer or intermediate paint for containers. Besides, it can also be used as intermediate paint or primer for new buildings and their maintenance in general atmosphere.

Application Guide

● Mixing:

Use the power mixer to mix the main paint evenly, and then as you stir it, you add the hardener until you get to mix well. Generally speaking, if the temperature is below 10 ℃, it needs 30 min induction time; if the temperature is over 10℃, it needs 15 min induction time

● Mixing Ratio:

Part A: Part B = 25:3 (by weight)

● Thinner:

Epoxy paint thinner

● Airless Spray:

Nozzle tip：0.018~0.027 inch

Spray pressure：15~18MPa

Thinner ratio：5~15% (by weight of paint)

● Brush, Roller:

Recommended Must achieve required thickness

DRYING SCHEDULE

SURFACE TREATMENT

All surfaces to be coated shall be clean, dry and without contaminants. The surface shall be evaluated and treated according to ISO8504 standard. Bare steel: Sand blasting to meet Sa2.5 (ISO8501-1:2007) standard. Depending on the environment of non-submerged part, it is acceptable to polish by power tools to meet at least St2.0 (ISO8501-1:2007) standard. Steel coated with workshop primer: make sure workshop primer surface is clean, dry and undamaged. Coated surface: applied on clean, dry, undamaged and compatible primer only.

APPLICATION

Application conditions: Substrate temperature shall be at 3 ℃ higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.

CLASSICAL COATING SYSTEM

Please inquiry JIANBANG Paint for specific coating solutions.

Epoxy Zinc Phosphate Anti-rust Primer: 2*50µm (dry film thickness)

Epoxy Mica Iron Oxide Paint: 2*50µm (dry film thickness)

.Service 01

Acrylic Polyurethane Finish: 2*40µm (dry film thickness)

SAFETY AND HEALTH

Please refer to MSDS before using this product. If you do not fully understand the restrictions, or cannot follow MSDS directions strictly, do not use this product. This volatile product is flammable. Keep this product away from flame or fire. Smoking is strictly prohibited in working area. Keep working area ventilated during application to make sure solvent vapor content is low in the air. PPE is necessary to avoid this product contacting with eyes or skin. More detailed safety tips are based on practical situation. Please handle used paint barrel correctly to avoid any pollution.

Storage:

Store this product in shady, dry, and ventilated warehouse. The shelf life is 12 months at room temperature. If exceeding shelf life, the products shall be tested before using.

Disclaimer:

All technical data given in this document is based on our knowledge achieved in lab and practice, it is not completely correct. Although we try to keep the validity of our advice, however we cannot predict the practical conditions that will affect paint quality. Herein, we cannot be responsible for the consequences of variations in such conditions, or for unforeseen conditions. We reserve the right to modify this document without informing in advance.

Certificate