Quality Epoxy Zinc Rich Primer Based On Epoxy Resin Ultra-fine...

这里可以自定义设置

PRODUCT DESCRIPTION

Epoxy Zinc Rich Primer is a two-component product based on epoxy resin, added with superfine zinc powder and polyamide curing agent. In accordance with the class 1, class2 and class 3 in HG/T3668-2009 type II, it is highly corrosion-resistant, highly anti-rust and has strong adhesion. Besides, it has the characteristics of small burn area during welding and cutting. As it is also oil, water and solvent resistant, it can be used with most anti-rust paints and finish coatings.

Typical Uses:

This product is widely used on sandblasted steel surface. Matched with suitable coatings, its corruption-resistant ability can be improved. It is highly recommended for steel pipes, storage tanks, steel structures, containers, etc.

这里可以自定义设置

PRODUCT SELLING POINT

● Nanotechnology, compact structure.

● The coating structure is designed independently.

● Import of 80% raw materials.

● Qualified for export of hazardous chemicals.

● Performance and color optimization customization.

PRODUCT ADVANTAGES

Provide construction plan and service

Performance and color optimization customization

The contract is guaranteed fo 20 years

Qualified for export of hazardous chemicals

这里可以自定义设置

PRODUCT PARAMETER

Mixingv	Use the power mixer to mix the main paint evenly, and then add the hardener and stir until it is well mixed. Generally, if the temperature below 10℃, it needs 30 min induction time; if the temperature over 10℃, it needs 15 min induction time.
Mixing ratio	Part A: Part B= 30:3 (by weight)
Thinner	Epoxy paint thinner
Airless spray	Nozzle tip: 0.025~0.031 inches Spray pressure: 18~28Mpa Thinner ratio: 5~15% (by weight of paint)
Brush、Roller	Recommended Must achieve required thickness

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	10 ℃	20 ℃	30 ℃
To touch(40um)	2h	1h	30min
To handle(40um)	24h	24h	12h
Pot life	6	4	2

* Make sure no chalking and other contaminations before recoating

* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions

PRODUCT SPECIFICATIONS

Color	Gray
Gloss	No gloss
Density	~1.92Kg/L (after mixing)
Hardness	Epoxy paint curing agent
Solid Volume	(45±2 )%
Standard Film thickness	80um dry film thickness (about 178um wet film thickness)
Theoretical spreading rate	2.93m²/Kg (80um dry film thickness)
Full Cure	(23±2℃)7d
Flash Point	27℃

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be at 3 ℃ higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.