Acrylic Aerial Aviation Sign Paint Designed For The Sign And Protection...

这里可以自定义设置

PRODUCT DESCRIPTION

This product is composed of hydroxy acrylic resin, organic silicon modified resin, lightfast pigment, curing agent, etc. Meanwhile, the coating has excellent resistance to weather, corrosion, acid, alkali, etc. Besides, it also has good construction performance, quick drying, low temperature construction, easy to use and so on.

Typical Uses:

This paint is mainly designed for high-altitude structure signs and protection such as the concrete chimney and transmission pole.

这里可以自定义设置

PRODUCT SELLING POINT

● Repair rate 0, no downtime cost.

● The coating structure is designed independently.

● Performance and color optimization customization.

● Provide construction plan and construction service.

● The contract is guaranteed for 20 years.

PRODUCT ADVANTAGES

Repair rate 0,no downtime cost

Acceptance of all

Extend the presservative time by 2.5 times

Save 250% maintenance cost

这里可以自定义设置

PRODUCT APPLICATION GUIDE

Mixing	Use the power mixer to mix the main paint evenly, and then as you stir it, you add the hardener until you get to mix well.
Thinner	Special thinner
Airless spray	Nozzle tip：0.017~0.023inch Spray pressure：15~18MPa Thinner ratio：0~15% (by weight of paint)
Brush、Roller	Recommended. Must achieve required thickness.

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	10 ℃	20 ℃	30 ℃
To touch(30um)	2h	1h	30min
To handle(50um)	8h	4h	3h
Min. recoating time	8h	4h	3h
Max. recoating time	-	-	-
Pot life	4h	2h	1h

* Make sure no chalking and other contaminations before recoating.

* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions.

PRODUCT SPECIFICATIONS

Color	Bright red, white
Gloss	Flat
Density	-1.3Kg/L
Hardnes	Polyurethane curing agent
Solid Volume	(50±2 )%
Film thickness	60µm dry film thickness (about 120µm wet film thickness)
Theoretical spreading rate	6.4m²/Kg(60µm dry film thickness)
Full Cure	(23±2℃) 24h
Flash point	31℃

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be at 3^oC higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.