B86-2 Road Marking Luminous Road Marking Paint

这里可以自定义设置

PRODUCT DESCRIPTION

The single component product is mainly prepared by acrylic resin, pigment, filler and auxiliaries. The main advantages of this product are great adhesion, and strong-level resistance to water, alkali and weather. Moreover, its film is clean and tenacious.

Typical Uses:

This product is designed for asphalt road marking.

这里可以自定义设置

Application Guide

● Mixing:

Single component, mixing well before using.

● Airless Spray:

Nozzle tip: 0.017~0.023 inches.

Thinner ratio: 0~15% (by weight of paint).

● Thinner:

Acrylic paint thinner.

● Spray, brush, roller:

Recommended for small areas only. Must achieve required thickness.

DRYING SCHEDULE

Substrate temperature	10 °C	20 °C	30 °C
To touch(40um)	2h	1h	30min
To handle(40um)	8h	4h	3h
Min. recoating time	8h	4h	3h
* Make sure no chalking and other contaminations before recoating.
* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions, humidity, mechanical strength, etc..

这里可以自定义设置

SURFACE TREATMENT

Concrete surface treatment:

a. First of all, it is necessary to confirm whether reliable damp-proof facilities are installed below the concrete base. The new concrete or cement base should be cured for at least 28 days, and its moisture content should not exceed 5%. The moisture content of the base should be evaluated by empirical method.

b. The base surface should be clean, solid and pollution-free, such as slurry and paint splashing, curing agent, grease and so on. For excessive float pulp, it is better to first use slight roughing, polishing, oil-stained ground, using electric angle grinder to polish.

c. The cracks and empty drum on the floor surface should be repaired first.

d. Whatever method is used to treat the surface, a clean, solid and dry base surface must be obtained. It is especially important that the grassroots should not be in a state of rising tide.

e. The base layer is cleaned and sanded with a sander.

APPLICATION

Application conditions: Substrate temperature shall be at 3 oC higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.

这里可以自定义设置

CLASSICAL COATING SYSTEM

Please inquiry JIANBANG paint for specific coating solutions.

Epoxy Sealing Primer: 30 µm (dry film thickness)

B86-2 Road Marking Paint: 2*50um (dry film thickness)

这里可以自定义设置

SAFETY AND HEALTH

Please refer to MSDS before using this product. If you do not fully understand the restrictions, or cannot follow MSDS directions strictly, do not use this product. This volatile product is flammable. Keep this product away from flame or fire. Smoking is strictly prohibited in working area. Keep working area ventilated during application to make sure solvent vapor content is low in the air. PPE is necessary to avoid this product contacting with eyes or skin. More detailed safety tips are based on practical situation.

Please handle used paint barrel correctly to avoid any pollution.

Storage:

Store this product in shady, dry, and ventilated warehouse. The shelf life is 12 months at room temperature. If exceeding shelf life, the products shall be tested before using.

Disclaimer:

All technical data given in this document is based on our knowledge achieved in lab and practice, it is not completely correct. Although we try to keep the validity of our advice, however we cannot predict the practical conditions that will affect paint quality. Herein, we cannot be responsible for the consequences of variations in such conditions, or for unforeseen conditions. We reserve the right to modify this document without informing in advance.