Underground Pipe Anticorrosive Paint High Quality Supplier In...

这里可以自定义设置

PRODUCT DESCRIPTION

The product is a two-component coating composed of epoxy resin, modified phenolic resin, new ST antirust filler, antirust additive, etc. Meanwhile, this paint has excellent resistance to alkali, acid, heat, water, etc. Besides, it also combines good moisture resistance and chemical stability.

Typical Uses:

It is mainly designed for all buried steel pipes, including the outer wall of hot net pipe, the outer wall of liquid storage tank, steel structure and concrete anti-corrosion under water or in dry and wet environment.

这里可以自定义设置

PRODUCT SELLING POINT

● Repair rate 0, no downtime cost.

● The coating structure is designed independently.

● Performance and color optimization customization.

● Provide construction plan and construction service.

● The contract is guaranteed for 20 years.

PRODUCT ADVANTAGES

Repair rate 0,no downtime cost

Acceptance of all

Extend the presservative time by 2.5 times

Save 250% maintenance cost

这里可以自定义设置

PRODUCT APPLICATION GUIDE

Mixing	Use the power mixer to mix the main paint evenly, and then as you stir it, you add the hardener until you get to mix well. Generally, if the temperature is below 10 ℃, it needs 30 min induction time; if the temperature is over 10℃, it needs 15 min induction time.
Mixing Ratio	Part A: Part B = 20:5 (by weight)
Thinner	Special thinner
Airless spray	Nozzle tip：0.018~0.025inch Spray pressure：18~25MPa Thinner ratio：0~15% (by weight of paint)
Brush、Roller	Recommended. Must achieve required thickness.

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	10 ℃	20 ℃	30 ℃
To touch(40um)	4h	2h	1h
To handle(40um)	24h	12h	6h
Min. recoating time	16h	8h	4h
Max. recoating time	10d	7d	5d
Pot life	4h	2h	1h

* Make sure no chalking and other contaminations before recoating.

* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions,humidity, mechanical strength, etc.

PRODUCT SPECIFICATIONS

Color	Customized
Gloss	Glossy
Density	-1.32Kg/L(after mixing)
Hardnes	Epoxy paint curing agent
Solid Volume	(50±2 )%(after mixing)
Standed Film thickness	80µm dry film thickness (about 160µm wet film thickness)
Theoretical spreading rate	4.73m²/Kg(60µm dry film thickness)
Full Cure	(23±2℃) 24h
Flash point	27℃

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be at 3 ℃ higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.