Weather And Water Resistant Chlorinated Rubber Finish Paint

这里可以自定义设置

PRODUCT DESCRIPTION

Chlorinated Rubber Finish is based on chlorinated rubber resin and has excellent weather resistance and good water resistance. This paint dries very fast. More importantly, it is strongly adhesive and can be used in low temperature.

Typical Uses:

This product is mainly applied as protective or decorative coating on the surface of ships, offshore buildings and petrochemical steel structures.

这里可以自定义设置

Application Guide

● Mixing:

Ready to use.

● Thinner:

Chlorinated rubber thinner

● Airless spray:

Nozzle tip: 0.017~0.023 inches

Spray pressure: 18~25Mpa

Thinner ratio: 0~10% (by weight of paint)

● Brush, Roller:

Recommended

Must achieve required thickness

DRYING SCHEDULE

Substrate temperature	10°C	20 °C	30°C
To touch(30um)	4h	2h	1h
To handle(30um)	48h	24h	12h
Min. recoating time	12h	6h	3h
Max. recoating time	-	-	-
* Make sure no chalking and other contaminations before recoating.
* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions, humidity, mechanical strength, etc.

这里可以自定义设置

SURFACE TREATMENT

All surfaces to be coated shall be clean and dry. The surface shall be evaluated and treated according to ISO8504 standard.
For bare steel, it shall be sandblasted to reach Sa2.5(iso8501-1:2007) standard. Depending on the environment of the non-immersed part, grinding with power tools is acceptable but shall at least reach St2(iso8501-1:2007) standard.
For shop primed steel, the shop primer shall be clean, dry and approved.
For surface painted coatings, this product can apply only to clean, dry and good compatible primer.

APPLICATION

Application conditions: Substrate temperature shall be at 3 ℃higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.

这里可以自定义设置

CLASSICAL COATING SYSTEM

Please inquiry JIANBANG Paint for specific coating solutions.

Classic Coating System

Chlorinated Rubber Anti-rust Paint------primer

2*30 µm (dry film thickness)

Chlorinated Rubber Mica Iron Oxide Intermediate Paint------intermediate paint

2*40 µm (dry film thickness)

Chlorinated Rubber Finish------finish

2*30μm(dry film thickness)

这里可以自定义设置

SAFETY AND HEALTH

Please refer to MSDS before using this product. If you do not fully understand the restrictions, or cannot follow MSDS directions strictly, do not use this product. This volatile product is flammable. Keep this product away from flame or fire. Smoking is strictly prohibited in working area. Keep working area ventilated during application to make sure solvent vapor content is low in the air. PPE is necessary to avoid this product contacting with eyes or skin. More detailed safety tips are based on practical situation.
Please handle used paint barrel correctly to avoid any pollution.

Storage:

Store this product in shady, dry, and ventilated warehouse. Under room temperature, the shelf life is 12 months. If exceeding shelf life, the products shall be tested before using.

Disclaimer:

All technical data given in this document is based on our knowledge achieved in lab and practice, it is not completely correct. Although we try to keep the validity of our advice, however we cannot predict the practical conditions that will affect paint quality. Herein, we cannot be responsible for the consequences of variations in such conditions, or for unforeseen conditions. We reserve the right to modify this document without informing in advance.