Advanced Glossy Outdoor Pure Acrylic Latex Paint
PRODUCT DESCRIPTION
Typical Uses:
This product can be applied on concrete, cement mortar, plaster and other substrate. In addition, it is mainly designed for the decoration of interior and exterior walls as well as the special finish coating for composite embossed latex paint.
Application Guide
● Mixing:
Ready to use.
● Thinner:
Clean water
● Airless spray:
Nozzle tip: 0.017~0.023 inches
Spray pressure: 15~18Mpa
Thinner ratio：0~10% (by weight of paint)
● Brush, Roller:
Recommended
Must achieve required thickness
DRYING SCHEDULE
Substrate temperature | 10°C | 20°C | 30°C |
To touch(20um) | 4h | 1h | 40min |
To handle(20um) | 24h | 24h | 20h |
| Min. recoating time | 24h | 1h | 40min |
| Max. recoating time | - | - | - |
* Make sure no chalking and other contaminations before recoating. | |||
* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions, humidity, mechanical strength,etc. | |||
SURFACE TREATMENT
The quality of cement mortar and concrete base shall conform to JGJ73-9Construction acceptance code for architectural decoration engineering. With the PH value less than 10, the base surface must be clean, dry, solid and free from oil and other dirt. In case of old coating film wall, the loose, detached and powder coating shall be removed. Besides, the surface shall be smooth by burnished. In case of wall with mildew, wash the wall with hot water containing 25% bleach, and leave the detergent on the surface for 10 minutes. Then rinse the surface thoroughly with clean water, and coat it after drying for 48 hours. In addition, use the exclusive putty for construction materials of the company to fill the gap and smooth the rough surface. Furthermore, please paint after the wall is dry as soon as possible to avoid re-contamination.
APPLICATION
Application conditions: Substrate temperature shall be 3 ℃ higher than dew point with relative humidity below 85%. Measurement of temperature and humidity should be conducted close to substrate.
CLASSICAL COATING SYSTEM
Please inquiry JIANBANG Paint for specific coating solutions.
Classic Coating System
Advanced Construction Latex Coating Sealing Primer
1*20 µm (dry film thickness)
Advanced Exterior Wall Putty
1~2 mm (dry film thickness)
Advanced Construction Latex Finish Paint
2*60 μm(dry film thickness)
SAFETY AND HEALTH
Please refer to MSDS before using this product. If you do not fully understand the restrictions, or cannot follow MSDS directions strictly, do not use this product. With low VOC volatilization, this coating is waterborne, safe and environmental friendly. Specific security measures depend on the construction and working environment. PPE is necessary to avoid this product contacting with eyes or skin. More detailed safety tips are based on practical situation.
Please handle used paint barrel correctly to avoid any pollution.
Storage:
Store this product in shady, dry, and ventilated warehouse away from heat sources. Storage temperature should be above 0 ℃. At room temperature, the shelf life is 6 months. If exceeding shelf life, the product shall be tested before using.
Disclaimer:
All technical data given in this document is based on our knowledge achieved in lab and practice, so it is not completely correct. Although we try to keep the validity of our advice, we cannot predict the practical conditions that will affect paint quality. Herein, we cannot be responsible for the consequences of variations in such conditions, or for unforeseen conditions. We reserve the right to modify this document without informing in advance.
Packing size | Packing weight |
| 20L | 20KG |
Certificate