Alkyd Iron Oxide Red Anti-rust Paint

这里可以自定义设置

PRODUCT DESCRIPTION

This anti-rust paint, free from lead, is mainly composed of modified alkyd resin. Significantly, it has great performance in non-toxicity, adhesion, rust-resistance and nitrate-resistance. Besides, this coating is provided with favourable durability under general climate conditions.

Typical Uses:

This product can be applied as primer for steel structure above waterline and on land.

这里可以自定义设置

PRODUCT SELLING POINT

● The epoxy floor paint is mainly prepared by epoxy resin, curing agent, dispersant and aggregates depend on requirements.

● Main advantages of this paint are great resistance of slippery, electrostatic, acid and alkali.

● Moreover, it also has good resistance to organic solvent, heavy load and abrasion.

● Besides, it combines incredible hardness and bonding power to provide a heavy duty and to be used as topcoat.

PRODUCT ADVANTAGES

Extend the service life by 2-3 years

Resistance (chemical medium) 98% sulfuric acid, 30% hydrochloric acid carefree

Five years bright as new, 5.99% Improve the yield of sensitive devices by 99%

50% Avoid slips and increase safety by 50%

这里可以自定义设置

PRODUCT PARAMETER

Mixingv	Ready to use
Thinner	Exclusive thinner for alkyd paint
Airless spray	Nozzle tip: 0.017~0.023 inches Spray pressure: 15~18Mpa Thinner ratio: 5~15% (by weight of paint)
Brush, Roller	Recommended Must achieve required thickness

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	10 ℃	20 ℃	30 ℃
To touch	5h	1h	30min
To handle	48h	24h	12h
Min. recoating time	36h	24h	12h

* Make sure no chalking and other contaminations before recoating

* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions

PRODUCT SPECIFICATIONS

Color	Iron-red
Gloss	Matt, Flat
Density	~1.5Kg/L
Solid Volume	(44±2 )%
Standard Film thickness	80um dry film thickness (about 182um wet film thickness)
Theoretical spreading rate	3.67m²/Kg (80um dry film thickness)
Flash Point	25 ℃

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be at 3 ℃ higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.