China Professional Inorganic Zinc-rich Primer Factory Anti Rust Paint |...

这里可以自定义设置

PRODUCT DESCRIPTION

This product is composed of alkyl silicate solution, ultrafine metal powder, color pigment, various additives, etc. With high content of zinc powder, its film has superior cathodic protection and great weather ability. Furthermore, the coating can withstand high temperature up to 400℃.

Typical Uses:

This product is widely designed as the anti-rust primer for the ferrous metal such as bridges, steel structure, iron tower and vehicles. Meanwhile, it can be used as the shop primer.

这里可以自定义设置

PRODUCT SELLING POINT

● 80% Zinc Content

● Cathodic Protection

● 500℃ High Temperature Resistance

● Great resistance to water ,oil and salt

PRODUCT ADVANTAGES

Extend the service life by 2-3 years

Resistance （chemical medium）98% sulfuric acid ,30% hydrochloric acid carefree

Five years bright as new ,5.99% improve the yield of sensitive devices by 99%

50% Avoid slips and increase safety by 50%

这里可以自定义设置

PRODUCT PARAMETER

Mixingv	Use the power mixer to mix the main paint evenly, and then as you stir it, you add the hardener until you get to mix well. Generally, if the temperature below 10 ℃, it needs 30 min induction time; if the temperature over 10℃, it needs 15 min induction time.
Mixing ratio	Part A: Part B = 24:6 (by weight)
Thinner	Inorganic exclusive thinner
Airless spray	Nozzle tip: 0.017~0.023inches Spray pressure: 15~18Mpa Thinner ratio: 5~15% (by weight of paint)
Brush、Roller	Recommended Must achieve required thickness

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	10 ℃	20 ℃	30 ℃
To touch(30um)	6h	1h	0.5h
To handle(30um)	24h	8h	4h
Min. recoating time	24h	1h	0.5h
Pot life	4h	2h	1h

* Make sure no chalking and other contaminations before recoating

* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions

PRODUCT SPECIFICATIONS

Color	Gray
Gloss	Flat
Density	~2.1Kg/L
Solid Volume	(45±2)%
Standard Film thickness	60um dry film thickness (about 222um wet film thickness)
Theoretical spreading rate	3.57m²/Kg (100um dry film thickness)
Flash Point	35℃

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be at 3 ℃ higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.