Chlorosulfonated Polyethylene Anti-corrosion Primer

这里可以自定义设置

PRODUCT DESCRIPTION

This two-component product is composed of chlorosulfonated polyethylene by adding modified resin, rust-resistance pigment, filler, solvent, etc. It’s impressive that the coating can exceedingly resist corrosion. Besides, the fast-drying paint has hard film, strong adhesion, and good bottom fitness. Additionally, the iron-red primer is bright while the brown one has outstanding shielding characteristic.

Typical Uses:

This product is widely used as rust-resistant primer for metal surface as well as concrete surface.

这里可以自定义设置

PRODUCT SELLING POINT

● The epoxy floor paint is mainly prepared by epoxy resin, curing agent, dispersant and aggregates depend on requirements.

● Main advantages of this paint are great resistance of slippery, electrostatic, acid and alkali.

● Moreover, it also has good resistance to organic solvent, heavy load and abrasion.

● Besides, it combines incredible hardness and bonding power to provide a heavy duty and to be used as topcoat.

PRODUCT ADVANTAGES

Extend the service life by 2-3 years

Resistance (chemical medium) 98% sulfuric acid, 30% hydrochloric acid carefree

Five years bright as new, 5.99% Improve the yield of sensitive devices by 99%

50% Avoid slips and increase safety by 50%

这里可以自定义设置

PRODUCT PARAMETER

Mixingv	Use the power mixer to mix the main paint evenly, and then as you stir it, you add the hardener until you get to mix well.
Thinner	Exclusive thinner
Airless spray	Nozzle tip: 0.018~0.025 inches Spray pressure: 18~25Mpa Thinner ratio: 5~15% (by weight of paint)
Brush, Roller	Recommended Must achieve required thickness

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	10 ℃	20 ℃	30 ℃
To touch(40um)	2.5h	1h	0.5h
To handle(40um)	48h	24h	12h
Min. recoating time	12h	4h	2h
Max. recoating time	6h	4h	2h

* Make sure no chalking and other contaminations before recoating

* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions

PRODUCT SPECIFICATIONS

Color	Iron-red
Gloss	No gloss
Density	~1.43Kg/L
Solid Volume	(55±2 )%
Standard Film thickness	80um dry film thickness (about 145um wet film thickness)
Theoretical spreading rate	4.8m²/Kg (80um dry film thickness)
Flash Point	38 ℃

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be at 3 ℃ higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.