Epoxy Glass Flakes Anti-rust Paint

这里可以自定义设置

PRODUCT DESCRIPTION

This two-component thick film coating is composed of epoxy resin, amine adduct curing agent, glass flakes, pigment, etc. Significantly, its film has excellent impermeability, strong adhesion and high mechanical strength. Besides, it also has great resistance to abrasion, cracks, vibrations. Furthermore, this paint can exceedingly withstand water and chemicals, with long-term anti-corrosion performance.

Typical Uses:

This product is used as the heavy anti-corrosion coating for marine engineering facilities, offshore platforms, oil pipelines, and large-scale penstocks of hydroelectric stations. Meanwhile, it is also suitable for bridges, gates, gas cabinets, buried pipelines, etc.

这里可以自定义设置

PRODUCT SELLING POINT

● The epoxy floor paint is mainly prepared by epoxy resin, curing agent, dispersant and aggregates depend on requirements.

● Main advantages of this paint are great resistance of slippery, electrostatic, acid and alkali.

● Moreover, it also has good resistance to organic solvent, heavy load and abrasion.

● Besides, it combines incredible hardness and bonding power to provide a heavy duty and to be used as topcoat.

PRODUCT ADVANTAGES

Extend the service life by 2-3 years

Resistance (chemical medium) 98% sulfuric acid, 30% hydrochloric acid carefree

Five years bright as new, 5.99% Improve the yield of sensitive devices by 99%

50% Avoid slips and increase safety by 50%

这里可以自定义设置

PRODUCT PARAMETER

Mixingv	Use the power mixer to mix the main paint evenly, and then as you stir it, you add the hardener until you get to mix well. Generally, if the temperature below 10℃, it needs 30 min induction time; if the temperature over 10 ℃, it needs 15 min induction time.
Mixing ratio	Part A: Part B = 25:3
Thinner	Exclusive epoxy paint thinner Thinner ratio: 5%~15% (by weight of paint)
Brush, Roller	Recommended Must achieve required thickness

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	10 ℃	20 ℃	30 ℃
To touch(50um)	7h	4h	3h
To handle(50um)	48h	48h	48h
Min. recoating time	11h	6h	4h
Max. recoating time	15d	10d	7d
Pot life	6h	4h	2h

* Make sure no chalking and other contaminations before recoating

* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions

PRODUCT SPECIFICATIONS

Color	Iron-red, Gray, Black
Gloss	Matte, Flat
Density	~1.4Kg/L (after mixing)
Hardness	Epoxy paint curing agent
Solid Volume	(60±2 )%
Standard Film thickness	100um dry film thickness (about 167um wet film thickness)
Theoretical spreading rate	4.28m²/Kg (100um dry film thickness)
Full Cure	(23±2℃)7d
Flash Point	38 ℃

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be at 3 ℃ higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.