Custom Epoxy Putty Factory From China

这里可以自定义设置

PRODUCT DESCRIPTION

Epoxy putty is a multi-purpose patching, sealing and mending compound. leaks,holes or cracks in materials can be repaired by the two part epoxy putty stick. When using metalworking tools, epoxy putty can be machined,drilled or tapped.

Typical Uses:

This product can be applied on substrate such as concrete and mainly used as intermediate coat for epoxy flooring system.

这里可以自定义设置

PRODUCT SELLING POINT

● The epoxy floor paint is mainly prepared by epoxy resin, curing agent, dispersant and aggregates depend on requirements.

● Main advantages of this paint are great resistance of slippery, electrostatic, acid and alkali.

● Moreover, it also has good resistance to organic solvent, heavy load and abrasion.

● Besides, it combines incredible hardness and bonding power to provide a heavy duty and to be used as topcoat.

PRODUCT ADVANTAGES

Extend the service life by 2-3 years

Resistance (chemical medium) 98% sulfuric acid, 30% hydrochloric acid carefree

Five years bright as new, 5.99% Improve the yield of sensitive devices by 99%

50% Avoid slips and increase safety by 50%

这里可以自定义设置

PRODUCT PARAMETER

Mixingv	Use the power mixer to mix the main paint evenly, and then as you stir it, you add the hardener until you get to mix well. Generally, if the temperature below 10 ℃, it needs 30 min induction time; if the temperature over 10℃, it needs 15 min induction time.
Mixing ratio	Part A: Part B= 20:5 (by weight)
Thinner	X-7 Epoxy Paint Thinner
Airless spray	Nozzle tip：0.021~0.025 inch Spray pressure：15~18 MPa Thinner ratio：0~10% (by weight of paint)
Brush、Roller	Recommended for small areas only. Must achieve required thickness.

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	10 ℃	20 ℃	30 ℃
To touch	4h	2h	1h
To handle	24h	12h	6h
Min. recoating time	16h	8h	4h
Max. recoating time	10d	7d	5d
Pot life	4h	2h	1h

* Make sure no chalking and other contaminations before recoating

* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions

PRODUCT SPECIFICATIONS

Color	Light Yellow
Gloss	Low Glossy
Density	1.85Kg/L
Cured Hardness	84 Shore D @ 60 minutes
Solid Volume	(60±2 )%
Temperature Resistance	Dry: 250°F/Wet: 125°F
To touch,minutes@23±2 °C	≤10
To handle, hours@23±2 °C	≤12
Flash Point	33 ℃

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be at 3 ℃ higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.