Epoxy Zinc Phosphate Anti-rust Paint

这里可以自定义设置

PRODUCT DESCRIPTION

This product is a two-component epoxy paint composed of epoxy resin and polyamide curing agent. Meanwhile, the paint contains zinc phosphate corrosion inhibitor pigment. It has excellent anti-corrosive performance and hard film. Besides, it also has strong impact resistance and wear resistance.

Typical Uses:

This product can be used as primer or intermediate paint for containers. Besides, it can also be used as intermediate paint or primer for new buildings and their maintenance in general atmosphere.

这里可以自定义设置

PRODUCT SELLING POINT

● Nanotechnology, compact structure.

● Salt spray corrosion resistance ≥3000h,Resistance to aging≥5000h.

● 98% concentrated sulfuric acid for 1200h.

● Resistance to 30% hydrochloric acid for 1200h.

●Factory direct sale.

PRODUCT ADVANTAGES

Repair rate 0, no downtime cost.Acceptance of all.

Extend the preservative time by 2.5 times.

Qualified for export of hazardous chemicals.

Performance and color optimization customization

这里可以自定义设置

PRODUCT APPLICATION GUIDE

Mixing

Use the power mixer to mix the main paint evenly, and then as you stir it, you add the hardener until you get to mix well. Generally speaking, if the temperature is below 10 ℃, it needs 30 min induction time; if the temperature is over 10℃, it needs 15 min induction time.

Thinner

Epoxy paint thinner

Mixing ratio

Part A: Part B = 25:3 (by weight)

Airless spray

Nozzle tip: 0.018~0.027 inches

Spray pressure: 15~18Mpa

Thinner ratio: 5~15% (by weight of paint)

Brush, Roller

Recommended

Must achieve required thickness.

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	10 ℃	20 ℃	30 ℃
To touch(50um)	2h	1h	30min
To handle(50um)	24h	12h	8h
Min. recoating time	6h	6h	4h
Pot life	6h	4h	2h

* Make sure no chalking and other contaminations before recoating. If necessary, stucco thoroughly before coating.

* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions, humidity, mechanical strength, etc.

PRODUCT SPECIFICATIONS

Color	Gray, Iron red
Gloss	Flat
Density	~1.42Kg/L(after mixing)
Hardness	Epoxy zinc phosphate curing agent
Solid Volume	(50±2 )%
Standard Film thickness	100um dry film thickness (about 200um wet film thickness)
Theoretical spreading rate	3.52m²/Kg (100um dry film thickness)
Full cure	(23±2℃) 7d
Flash point	25℃

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be at 3 ℃ higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.