Fast Drying Reflective Heat Insulation Coating With Anti-corrosion And...

这里可以自定义设置

PRODUCT DESCRIPTION

This product is composed of polymer synthetic resin, special resin, heat insulation and rust proof filler, organic solvent, etc. Meanwhile, the paint can achieve external cooling effect, especially the tank, tank truck in high temperature environment in summer. This coating can reduce the summer high temperature to the threat of oil tank, such as the sun heat isolation and reflection, in order to achieve heat insulation, and make the object surface and internal temperature difference. Besides, the coated film glue has the anti-corrosion decorative effect in the premise of heat insulation and temperature reduction.

Typical Uses:

It is suitable for metal oil tank, chemical storage tank, liquefied gas spherical tank and oil tank truck. Meanwhile, this paint also plays the role of the insulation cooling for the chemical pipeline, refrigerated truck, concrete, wood products, etc.

这里可以自定义设置

PRODUCT SELLING POINT

● Repair rate 0, no downtime cost.

● The coating structure is designed independently.

● Performance and color optimization customization.

● Provide construction plan and construction service.

● The contract is guaranteed for 20 years.

PRODUCT ADVANTAGES

Repair rate 0, no downtime cost

Acceptance of all

Extend the preservative time by 2.5 times

Save 250% maintenance cost

这里可以自定义设置

PRODUCT APPLICATION GUIDE

Mixing	Use the power mixer to mix the main paint evenly, and then as you stir it, you add the hardener until you get to mix well.
Mixing Ratio	Part A: Part B= 20:4 (by weight)
Thinner	Exclusive thinner
Airless spray	Nozzle tip：0.018~0.025inch Spray pressure：18~25MPa Thinner ratio：0~15% (by weight of paint)
Brush、Roller	Recommended for small areas only. Must achieve required thickness.
Roller coater	Not recommended.

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	10 ℃	20 ℃	30 ℃
To touch(25um)	4h	2h	1h
To handle(25um)	24h	12h	6h
Min. recoating time	16h	8h	4h
Max. recoating time	10d	7d	5d
Use time after mixing	4h	2h	1h

* Make sure no chalking and other contaminations before recoating.

* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions,humidity, mechanical strength, etc.

PRODUCT SPECIFICATIONS

Color	Customized
Gloss	Flat
Density	-1.36Kg/L(after mixing)
Hardeness	Silicone curing agent
Solid Volume	(44±2 )%
Standard Film thickness	50µm dry film thickness (about 114µm wet film thickness)
Theoretical spreading rate	6.47m²/Kg(50µm dry film thickness)
Full cure	(23±2℃) 7d
Flash point	27℃

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be 3 ℃ higher than dew point with relative humidity below 85%. Measurement of temperature and humidity should be conducted close to substrate.