Self-leveling Epoxy Floor Paint

这里可以自定义设置

PRODUCT DESCRIPTION

This two component product is based on epoxy resin and high quality curing agent. The main advantages of paint are smooth surface, beautiful and mirror effect. This paint combines incredible hardness and bonding power to provide a heavy duty and to be used as topcoat. Furthermore, it has excellent resistance to acid, alkali, oil and chemical corrosion.

Typical Uses:

This product is used for high requirements for clean, beautiful, dust-free, sterile electronics and microelectronics industry. Moreover, it can be used for other industries that require abrasion resistance, impact resistance and chemical corrosion prevention.

这里可以自定义设置

PRODUCT SELLING POINT

● The epoxy floor paint is mainly prepared by epoxy resin, curing agent, dispersant and aggregates depend on requirements.

● Main advantages of this paint are great resistance of slippery, electrostatic, acid and alkali.

● Moreover, it also has good resistance to organic solvent, heavy load and abrasion.

● Besides, it combines incredible hardness and bonding power to provide a heavy duty and to be used as topcoat.

PRODUCT ADVANTAGES

Extend the service life by 2-3 years

Resistance (chemical medium) 98% sulfuric acid, 30% hydrochloric acid carefree

Five years bright as new, 5.99% Improve the yield of sensitive devices by 99%

50% Avoid slips and increase safety by 50%

这里可以自定义设置

PRODUCT PARAMETER

Mixingv	Use the power mixer to mix the main paint evenly, and then as you stir it, you add the hardener until you get to mix well. Generally, if the temperature below 10 ℃, it needs 20 min induction time; if the temperature over 10℃, it needs 15 min induction time.
Mixing ratio	Part A: Part B= 20:5 (by weight)
Scrape coating	Uniform smooth, must be required dry film thickness

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	10 ℃	20 ℃	30 ℃
To touch	4h	2h	1h
To handle	24h	12h	6h
Min. recoating time	16h	8h	4h
Max. recoating time	10d	7d	5d
Pot life	1.5h	1h	0.5h

* Make sure no chalking and other contaminations before recoating

* Above data for reference only, actual drying time and recoating time is dependent on temperature, dry film thickness, ventilation conditions

PRODUCT SPECIFICATIONS

Color	Custom color
Gloss	Glossy
Density	~1.32Kg/L(after mixing)
Hardness	Epoxy paint curing agent
Solid Volume	(98±2)%
Standard Film thickness	1mm dry film thickness (about 1.02mm wet film thickness)
Theoretical spreading rate	0.74m²/Kg (1mm dry film thickness)
Full Cure	(23±2℃) 7d
Flash Point	27 ℃

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be at 3 ℃ higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.